国产在线精品亚洲一区二区三区

    <video id="efny6"></video>
  • <form id="efny6"></form>
  • <mark id="efny6"></mark>
  • <s id="efny6"></s>

      歡迎光臨!濟南聯眾供熱設備廠,主營:山東燃氣鍋爐,山東電采暖鍋爐,山東多介質過濾器和射線防護器材等。
    1. 服務熱線:18678809986
    2. 首頁 關于我們 產品中心 新聞中心 工程案例 設備選型 聯系我們
    3. 您的位置:首頁> 新聞中心 >

      不銹鋼過濾器濾芯的保養應該注意什么?
      來源:http://www.t0554.com 發布時間:2020-10-20

      1.不銹鋼過濾器長期未得以應用時,我們必須要將過濾器內部的濾液排放干凈,然后將濾芯拿出,進行洗凈烘干流程,當完成這一系列操作后,將產品放入干凈的塑料袋內并封口,這是為了保證濾芯產品不被污染.,將不銹鋼過濾器擦凈存放于干燥處即可.
      1. When the stainless steel filter has not been used for a long time, we must discharge the filtrate inside the filter, and then take out the filter element for cleaning and drying process. After completing this series of operations, put the product into a clean plastic bag and seal it to ensure that the filter element product is not polluted. Finally, clean the stainless steel filter and store it in a dry place
      2.一般,換下來的濾芯要浸泡于酸性強度強的洗液中,浸泡時長約為24小時左右,切記,酸性液體的溫度要保持于25-50度左右,在進行浸泡的過程中時,我們建議酸與堿占液體的比例要控制在20%之間,這是為了避免液體對濾芯產品內部的破壞與污染.
      2. Generally, the replaced filter element should be immersed in strong acid detergent for about 24 hours. Remember that the temperature of acid liquid should be kept at about 25-50 degrees. In the process of soaking, we suggest that the ratio of acid and alkali to liquid should be controlled between 20%, which is to avoid the damage and pollution of the liquid to the filter element
      山東多介質過濾器
      3.一般而言,蛋白因子較高的洗液產品好,不管是從清潔度上還是節約上而言,效果都很好.因此,應當利用蛋白含量較高的酶溶液進行清洗.當清理過后,一定要進行二次清洗,并采用蒸汽進行整體消毒,這流程對過濾器的保養更為重要.
      3. Generally speaking, the detergent with high protein factor is good, and the effect is good both in terms of cleanliness and economy. Therefore, enzyme solution with high protein content should be used for cleaning. After cleaning, it is necessary to carry out secondary cleaning and steam disinfection, which is the most important process for the maintenance of the filter
      4.不銹鋼過濾器在消毒過程中要注意一定的時間和溫度,通常,內部的濾芯產品要在消毒柜中放置130℃/20分鐘,消毒溫度不宜超過150℃,更長消毒時間不能超過30分鐘.要切記,一旦消毒溫度過高,抑或時間長、壓力大,都會導致過濾器內部元件(濾芯)的整體損壞.
      4. Pay attention to certain time and temperature in the process of disinfection of stainless steel filter. Generally, the internal filter element should be placed in the disinfection cabinet at 130 ℃ / 20 minutes. The disinfection temperature should not exceed 150 ℃ and the longest disinfection time should not exceed 30 minutes. It should be noted that once the disinfection temperature is too high, or the time is long and the pressure is high, the internal components (filter element) of the filter will be damaged
      由此可見,無論是不銹鋼過濾器濾芯的清洗還是長期不使用之后的維護與保養工作,其步驟都異常復雜,我們需要多多了解其中的細節部分才能真正掌握其中的訣竅.
      It can be seen that whether it is the cleaning of stainless steel filter element or the maintenance after long-term non use, the steps are extremely complex. We need to know more about the details to really grasp the knack
      以上的內容就是山東多介質過濾器為大家介紹的今日內容,更多內容還請大家關注網站:http://www.t0554.com我們會定期更新新的知識與內容為大家呈現.
      The above content is the content of today introduced by Shandong multi-media filter. For more information, please pay attention to the website: http://www.t0554.com We will regularly update new knowledge and content for you to present

      魯公網安備 37011302000227號

      国产在线精品亚洲一区二区三区
        <video id="efny6"></video>
    4. <form id="efny6"></form>
    5. <mark id="efny6"></mark>
    6. <s id="efny6"></s>